• Enclosure protection test
• Corrosion protection test
• Ambient temperature
• Definition of “cycles” test
• Definition of “starts” test
• Vibration resistance
If the actual ambient temperatures exceed an average of +40 °C, the lambda values have to
be incremented by a safety factor. For an average temperature of +60 °C, this factor is
specified to 2.5.
For environmental test, actuator and actuator controls will be subjected to the following tests:
• Dry heat test
• Damp heat test
• Vibration test
• Induced seismic vibration (earthquake)
• Enclosure protection IP68 test
• Salt spray test
• Immunity requirements test
• Emission test
To Next Page
