AUMA SA3 - Default Chapter; Table of Contents

2
NOTICE for use!
This document is only valid with the latest operation instructions attached to the device, the attached manual as
well as the pertaining technical and electrical data sheets respectively. They are understood as reference
documents.
Purpose of the document:
The present document informs about the actions required for using the device in safety-related systems in
accordance with IEC 61508 / IEC 61511.
Reference documents:
• Operation instructions (Assembly, operation, commissioning) for actuator.
• Manual (Operation and setting) 3.XX NI.
• Manual (Device integration Fieldbus) 3.XX NI Profibus.
• Technical data on multi-turn actuator and actuator controls.
Reference documents can be downloaded from the internet (www.auma.co.in).
Table of Content
Sl. No.
Content
Page No.
1
Terminology
4-5
1.1
Abbreviations and concepts
2
Application and validity
2.1
Range of application
2.2
Standards
2
General information about Profibus DP
6-7
2.1
Basic characteristics
2.2
Basic functions of Profibus DP
2.3
Transfer mode
2.4
BUS access
2.5
Functionality
2.6
Protective functions
2.7
Device types
3
Commissioning
8-11
3.1
Introduction
3.2
Parameter setting
3.2.1
Settings for basic functionality for Profibus DP-V1
3.2.2
Settings for Profibus DP-V1 services
3.3
BUS address (slave address)
Table of Contents
Sl. No.
Content
Page No.
1
Terminology
5-6
1.1
Abbreviations and concepts
2
Application and validity
7
2.1
Range of application
2.2
Standards
2.3
Valid device types
3
Architecture, configuration and applications
8-12
3.1
Architecture (actuator sizing)
3.2
Configuration (setting)/version
3.3
Protection against uncontrolled operation (self-locking/brake)
3.4
Operation mode (low/high demand mode)
3.5
Further notes and indications on architecture
3.6
Applications (environmental conditions)
4
Safety instrumented systems and safety functions
13-16
4.1
Safety instrumented system including an actuator
4.2
Safety functions
4.3
Safe inputs and outputs
2
Multi-turn actuators
SA series with Control 3.XX /NI/SIL