AUMA SAVEx Series - Page 4

669.4. Output speed (internal): set
689.5. Fieldbus address (slave address), baud rate, parity and monitoring time: set
689.6. Test run
689.6.1. Direction of rotation at mechanical position indicator: check
699.6.2. Direction of rotation at hollow shaft/stem: check
709.6.3. Limit switching: check
7110. Commissioning (settings/options in the actuator).............................................................
7110.1. Switch compartment: open/close
7210.2. Mechanical position indicator (self-adjusting)
7210.2.1. Mechanical position indicator: set
7310.2.2. Gear stage of the reduction gearing: test/set
7410.3. Mechanical position indication via indicator mark (not self-adjusting)
7410.3.1. Mechanical position indicator: set
7510.3.2. Gear stage of the reduction gearing: test/set
7711. Corrective action....................................................................................................................
7711.1. Faults during operation/commissioning
7711.2. Fault indications and warning indications
8111.2.1. Signal "Motor protection tripped” (via TMS device)
8111.3. Fuses
8111.3.1. Fuses within the actuator controls
8111.3.2. Motor protection (thermal monitoring)
8312. Servicing and maintenance...................................................................................................
8312.1. Preventive measures for servicing and safe operation
8412.2. Disconnection from the mains
8412.2.1. Disconnection from the mains with KP/KPH and KES electrical connection
8512.2.2. Disconnection from the mains with KT/KM electrical connection
8612.3. Maintenance
8612.4. Disposal and recycling
8813. Technical data.........................................................................................................................
8813.1. Technical data Multi-turn actuators
9013.2. Technical data Actuator controls
9614. Spare parts.............................................................................................................................
9614.1. Multi-turn actuators SAVEx 07.2 – SAVEx 16.2/SARVEx 07.2 – SARVEx 16.2
9814.2. ACVExC 01.2 KP/KPH actuator controls
10014.3. ACVExC 01.2 KES actuator controls
10214.4. ACVExC 01.2 KT/KM actuator controls
10415. Certificates..............................................................................................................................
10415.1. Declaration of Incorporation and EU Declaration of Conformity
107Index........................................................................................................................................
110Addresses...............................................................................................................................
4
SAVEx 07.2 – SAVEx 16.2 / SARVEx 07.2 – SARVEx 16.2 Control unit: electronic (MWG)
Table of contents ACVExC 01.2 Non-Intrusive Modbus RTU