Page 37 of 51
6.3 FIRMWARE UPGRADE
The PVI-DESKTOP can be upgraded very simply. Upgrading is possible by two different methods: through
the USB 2.0 port and the Aurora Communicator software or directly through the SD card tab. It is
recommended using the first procedure as it is simpler and automatic.
NOTE: it is advisable to periodically verify new FW versions.
WARNING: it is strongly recommended to keep the system connected to a power source during
FW updating. Loss of power during FW updates may cause a system lock.
6.3.1 USB FIRMWARE UPDATING
• Download the latest version of the Aurora Communicator software. This can be done from the
link: http://www.power-one.it/digilab/Digi.aspx?Code=15
• Click Download to save the correct version (32 or 64bit).
• In case there are previous Aurora Communicator versions in the PC, it is recommended to
remove them before installing the new version.
• Close all other applications before proceeding with the new installation.
• Unzip the file and launch setup.exe to install.
• Launch the Aurora Communicator software and select from the Configuration menu the Aurora
PVI Desktop Update section.
To Next Page
Loading...
Need help?
General