11
N415A
H1/8 BLACK
(-) chassis ground connection: Connect this wire to bare metal, preferably with a factory bolt rather
than your own screw. Screws tend to either strip or loosen with time. All components, including the siren should
be grounded to the same point in the vehicle if possible.
H1/9 YELLOW
(+) ignition input: Connect this wire to the (+)12V ignition wire. This wire must show (+)12V with
the key in Run position and during cranking. Take care to insure that this wire cannot be shorted to the vehicle
chassis at any point.
H1/10 BROWN
(+) siren output: Connect this to the RED wire of the siren. Connect the BLACK wire of the siren
to (-) chassis ground, preferably at the same point you connect the control module’s BLACK ground wire.
H1/11 RED
(+)12V constant power input: Before connecting this wire, remove the supplied fuse. Connect to the
battery positive terminal or the constant 12V supply to the ignition switch.
NOTE: Always use a fuse within 12 inches of the point you obtain (+)12V. Do not use the 15A fuse in
the harness for this purpose. This fuse protects the module itself.
H1/12 RED/WHITE
(-) 200mA auxiliary channel/delayed accessory output: If programmed for an auxiliary output,
this wire will provide a (-) pulse when the lock button on the factory transmitter is pressed twice within three sec-
onds. This output can be used to control optional accessories. If programmed for delayed accessory output, this
wire will provide (-) ground when the ignition is turned off and will continue to output (-) ground until a door is
opened then closed. This can be used to energize the accessory circuit in the vehicle to keep the radio and other
accessories on after the ignition is turned off.
IMPORTANT! Never use this wire to drive anything but a relay or a low-current input! This
transistorized output can only supply (-) 200 mA, and connecting directly to a solenoid,
motor, or other high-current device will cause the module to fail.
FACTORY
BOLT
NOTE: REMOVE ANY PAINT
BELOW RING CONNECTOR
RING
CONNECTOR
GROUND
WIRE
To Next Page
Loading...
Need help?
General
