20
N415A
1 ACTIVE/PASSIVE ARMING:
When active arming is selected, the system will only arm when the transmitter is
used. When set to passive, the system will arm automatically 30 seconds after the last door is closed. To alert the
consumer of passive arming, the siren will chirp and the parling lights will flash 30 seconds after the door is
closed.
2 AUDIBLE ARM/DISARM CONFIRMATION ON/OFF:
This feature controls the chirps that confirm the arming
and disarming of the system. In the ON setting (default) the siren will provide audible confirmation when arming
and disarming the system. If programmed to the OFF position no siren chirps will be heard when arming and dis-
arming.
3 SIREN DURATION 30/60 SECONDS:
In the default setting, the full triggered sequence will continue when trig-
gered for 30 seconds. This can be changed to 60 seconds in the system features learn routine.
4 DOOR TRIGGER INSTANT/DELAYED:
In the instant (default) setting, if a door is opened while the security
system is armed the system will trigger immediately. In the delayed setting there is a 15 second delay before the
doors will trigger the system. This gives the user 15 seconds to disarm the system after a door is opened with-
out the factory transmitter.
5 DOOR TRIGGER ERROR CHIRP ON/OFF:
With the door trigger error chirp programmed off, the system will
not report an invalid zone on arming when the door trigger wire is active. This eliminates the extra chirps that
occur when interfacing with vehicles that have exceptionally long dome light delay circuits.
6 SENSOR SHUNT ZONES 2 AND 4/ALL ZONES:
In the default setting, all sensors with the exception of the
door zone will be bypassed when a trigger is grounded three seconds after a (+) pulse on the white/blue (trunk is
opened). If programmed to the all zones setting, all zones including the doors will be bypassed when the trunk is
opened with the factory transmitter.
7 PANIC/AUXILIARY OUTPUT:
In the default setting, pressing the lock button on the factory transmitter twice
within three seconds will trigger panic mode. If programmed to the auxiliary output setting, pressing the lock but-
ton twice within three seconds will send a (-) pulse on the RED/WHITE auxiliary output wire.
8 NO FUNCTION
9 VALET PULSE COUNT 1-5 PULSES:
The system can be programmed to count the number presses of the
valet switch before disarming the security system. The factory default setting is one pulse. The unit can be set for
2-5 pulses using Button II to select the setting.
Ghost Switch option: For added security, the GRAY wire on the two-pin valet/program can be
connected to any switch in the vehicle that provides a positive (+) momentary pulse.
FEATURES DESCRIPTIONS
To Next Page
Loading...
