9
N415A
This guide describes in detail the connection of each wire. Also included are possible applications of each wire.
This system was designed with the ultimate in flexibility and security in mind. Many of the wires have more than
one possible function. Please read carefully to ensure a thorough understanding of this unit.
Primary Harness, 12-pin connector
H1/1 ORANGE
(-) ground-when-armed output: This wire supplies a (-) ground as long as the system is armed.
This output ceases as soon as the system is disarmed. This wire controls operation of the pre-wired starter kill
relay and can be used to control other optional accessories.
NOTE: If connecting the orange wire to control another module, such as a 529T or 530T window
controller, a 1 amp diode (type 1N4004) will be required. Insert the diode as shown below.
IMPORTANT! Never interrupt any wire other than the starter wire.
H1/2 WHITE
light flash output: As shipped, this wire should be connected to the (+) parking light wire. If the light
flash polarity jumper inside the unit is moved to the opposite position (see Internal Jumpers, page 17), this wire
supplies a (-) 200 mA output. This is suitable for driving (-)parking light wires.
WIRE CONNECTION GUIDE
To Next Page
Loading...
Need help?
General
