10
N415A
H1/3 WHITE/BLUE
(+) trunk release/sensor shunt input: This input is used to bypass sensor inputs when the
trunk is opened using the factory transmitter. Connect this wire to the (+) trunk release output of the factory key-
less entry system or trunk release relay. When the system receives a (+) input on this wire, zones 2 and 4 are
bypassed for three seconds. If during that three seconds, ground is applied to the H1/6 BLUE wire zones 2 and
4 will remain bypassed until the ground input is removed. This means that when the trunk is opened with the fac-
tory transmitter the only triggers that remains active while the trunk is open are the doors. Three seconds after
the trunk is closed the bypassed zones will become active again.
H1/4 BLACK/WHITE
200 mA (-) domelight-supervision output: Connect this wire to the optional domelight
supervision relay.
IMPORTANT! This output is only intended to drive a relay. It cannot be connected directly to the
domelight circuit, as the output cannot support the current draw of one or more bulbs.
H1/5 GREEN
(-) door trigger input: Most vehicles use negative door trigger circuits. Connect the GREEN wire to
a wire which shows ground when any door is opened. In vehicles with factory delays on the domelight circuit,
there is usually a wire that is unaffected by the delay circuitry.
H1/6 BLUE
(-) instant trigger: This input will respond to a negative input with an instant trigger. It is ideal for
hood and trunk pins and will report on zone one.
H1/7 VIOLET
(+) door trigger input: This wire is used in vehicles that have a positive (+) switched dome light cir-
cuit . Connect the VIOLET wire to a wire that shows (+)12V when any door is opened, and ground when the
door is closed.
To Next Page
Loading...
Need help?
General
