AUTOFLAME Mk8 MM - Page 47

Error Message Description
32 VSD Feedback Change Too
Small
Feedback change detected during commissioning is too
small
 Check VSD feedback during commissioning
 Check option 99 for VSD on channel 5 and option 109 for VSD on channel 6
 Check wiring on terminals 1 – 3, 4 – 6, 10 – 12 and 13 – 15
33 Missing Commissioning Data Internal fault
 Check there is commissioning data for all options servomotors/VSD
34 FAR Execution Speed Internal fault
 Contact Autoflame approved local Tech Centre
35 Software Error Internal fault
 Contact Autoflame approved local Tech Centre
36 Software Error Internal fault
 Contact Autoflame approved local Tech Centre
37 Software Error Internal fault
 Contact Autoflame approved local Tech Centre
38 Software Error Internal fault
 Contact Autoflame approved local Tech Centre
39 VSD Sampling Error VSD feedback current/ voltage too high on channel 5/6
 Check wiring on terminals 1 – 3, 4 – 6, 10 – 12 and 13 – 15
40 VSD Feedback Too Low VSD feedback value is too low during commissioning on
channel 5/6
 Check VSD feedback while commissioning
41 APS Commission Data Fault No air pressure trim data for a point with EGA trim
 Check EGA trim and air pressure trim in fuel-air curve
42 Comm VPS Gas Pressure Low Commissioned gas pressure during VPS below option/
parameter 133 threshold
 Check option/ parameter 133 and check gas pressure
 Re-commission gas pressure sensor
43 Comm Running Gas Pressure
Low
Commissioned gas pressure during running below option/
parameter 136
 Check option/ parameter 136 and check gas pressure
 Re-commission gas pressure sensor
44 Comm Air Pressure Low Commissioned air pressure during running below option/
parameter s 147 and 149
 Check option/parameters 147 and 149
 Re-commission air pressure sensor
45 Software Error Internal fault
 Contact Autoflame approved local tech centre
46 Software Error Internal fault
 Contact Autoflame approved local tech centre
47 Expansion PF Output (Check F5) Internal fault
 Check wiring on terminal PF
 Check fuse 5 (2A) on expansion board
48 WL Alarm Output Internal Fault Internal fault
 Check expansion option 5
 Check wiring and voltages on terminals HAI, 1AI, 2AI
22.05.2017 Mk8 MM End User Guide Page 42
4 Errors and Lockouts