Automated Logic SE6166 User Manual

SE6166 Controller • Rev. 4/13/2011 12 © 2011 Automated Logic Corporation
Download the following items to the SE6166's battery-backed memory:
Item
Notes
Control program Must be in
WebCTRLx.x\webroot\
<system_name>
\programs
.
DRV_SE driver Must be in
WebCTRLx.x\webroot\
<system_name>
\drivers
.
NOTE
To verify that you have the driver's latest version, go to
http://accounts.automatedlogic.com/download, then select
Drivers
>
ExecB
. Compare the latest version to the SE6166's
driver in SiteBuilder.
Editable properties
Schedules
If you change any of these items or the SE6166's address after the initial download, you
must download again. The first download takes longer than subsequent downloads.
CAUTIONS
• The SE6166 will lose stored data when you download.
• Equipment controlled by the SE6166 will shut down and restart when you download.
You download the controller from WebCTRL. If your network is complete, you can
download from any network browser. If not complete, connect a laptop with a local copy of
the system database to the SE6166's local access port. See To communicate through the
local access port (page 20).
1 On WebCTRL's NET tree, select the controller.
2 Click Downloads.
3 Do one of the following:
○ If the controller is in the Downloads list, go to step 4.
○ If the controller is not in the list:
a. Click
Add.
b. In the pop-up, select the controller.
c. Select
All Content.
d. Click
Add.
e. Click
Close.
4 Select the controller in the Downloads list.
5 Click Start.
NOTES
• If the download fails, locate and resolve the problem, then retry the download.
• You can also download a controller from the Devices page.
Downloading the SE6166
To download in
WebCTRL

Automated Logic SE6166 Specifications

General

Brand	Automated Logic
Model	SE6166
Category	Controller
Language	English