Automatic Technology GDO-6v4 EasyRoller - Button Functions

Owner Installation Instructions GDO-6v4 EasyRoller
®
29
Parameters
Button Functions
Buttons Function
OPERATE Opens/Stops/Closes the door
pressing & holding will close the door in the event
of safety beam is not functioning
DOOR CODE Codes a transmitter button for operate, vacation,
auxiliary and pet functions
LIGHT CODE Codes a transmitter button for light function
FORCE MARGIN SET & OPEN Increases the obstruction force margin setting
FORCE MARGIN SET & CLOSE Decreases the obstruction force margin setting
FORCE MARGIN SET (then) SET Resets the factory default force margin settings
AUTO CLOSE TIME (then) OPEN Increases the Auto-Close delay time
AUTO CLOSE TIME (then) CLOSE Decreases the Auto-Close delay time
AUTO CLOSE TIME (then) SET Resets the factory default Auto-Close delay time
CLOSE (for 6 secs.) Clears the door limits set positions. Limits then
need to be reset
SET (then power on) & hold until all LED’s are off Deletes control parameters excluding transmitter
storage memory
DOOR CODE (then power on) & hold until all LED’s
are off
Deletes all transmitter storage memory
SET & DOOR CODE (the power on) and hold until all
LED’s are off
Deletes all control parameters and transmitter
storage memory.
SET Re-initialises the Opener to re-calculate force
margin