ZoneLogix™ PRO Zone Controller User Guide | Revision 1.0 November 2019 | Page 30
7.4
Breakout Module Example: Transfer Application
This example shows the setup of a transfer in a Branch. Based on the package flow, this Branch is going in the
Forward direction … EOB to Master. The Breakout Modules are used to break the Handshaking and allow the serial
communications to pass through. At Zone #5, we do not want the Handshaking between Zone #5 and Zone #4. This
wouldn’t make sense for the application. The Breakout Module “breaks” the Handshaking so that Zone #5 cannot
make a Request to Zone #4. This same scenario is true between Zone #3 and Zone #2.
Figure 18: Breakout Modules in a Transfer Application
To Next Page
Loading...