ZoneLogix™ PRO Zone Controller User Guide | Revision 1.0 November 2019 | Page 33
8.2
Firmware Version Display
Three (3) of the feedback LEDs are used to communicate the firmware revision of the Zone Controller during the start-
up sequence. Each time that power is applied to the board, the green (power) and red (fault) LEDs light up
immediately. After 1 second the amber LED flashes on for 0.75 seconds followed by an off period. An off period of
1.5 seconds represents a decimal point separating major revisions from minor revisions. An example is shown below:
Figure 20: Firmware Version Display Example
The example sequence above represents firmware revision 1.2. When the red (fault) LED turns off, the start-up
sequence has ended, and normal operation begins.
8.3
Additional Assistance
For updated revisions to our user manuals, visit our website: www.automationcontrolsgroup.com
For additional assistance, please contact:
Sales / Customer Service
(619) 677-6530
9
Document Revision History
The following changes have been made to this document:
To Next Page
Loading...