Avant e5
24
.
Auxiliary hydraulics oil flow
The graph below shows auxiliary hydraulics output
flow at different rpm levels of the electric motor. The
rpm of electric motor of the auxiliary hydraulics pump
is controlled with the hand throttle lever.
Some attachment may work optimally at certain flow
level, use the graph to estimate correct rpm setting.
The hand throttle lever controls
only the auxiliary hydraulic pumps.
The position of the hand throttle
lever does not affect the speed or
pushing power of the drive system.
Keep the rpm setting as low as
possible to smoothly operate the
attachment to conserve energy.
Pull the throttle lever back when
not operating an attachment.
Maximum auxiliary hydraulics oil
flow cannot be used with all
attachments. Check correct rpm
level for each attachment with the
help of this graph and the
Operator's Manual of each
individual attachment. Attachment
may get damaged, run too fast, or
it may be difficult to control
precisely when oil flow is too high.
.
Drive speed and pulling force
* The maximum speed of the loader is the highest
speed that can be achieved in optimal conditions.
Load distribution, tyre pressures, ground surface,
and many other conditions influence the maximum
speed.
** The pulling force depends on the size of the tyres.
In the table pulling force with each tyre model is
listed as comparison with the standard tyres (100 %).
https://tractormanualz.com
To Next Page
Loading...