Avant e5
28
.
Tipping load - load chart
With the load diagram below, you can estimate the
load handling capability of the loader.
The tipping load depends according to the distance
between the centre of gravity of the load and the
front axle of the loader.
The diagram represents the forward stability only. It
does not refer to maximum available lift force.
Avoid overloading the loader -
Know the load and lifting
capacity of the loader.Heavy load
can cause tipping over when
moving the load. The diagram is
valid only on firm and level ground,
with the conditions listed above.
When the boom is moved to
another position, the load can
exceed tipping load and loader can
tip over.
How to read the load chart
a Tipping load with the loader frame
in straight position.
b Tipping load with the loader frame
in maximum articulation.
ROC (Rated operating capacity),
defined as 60 % of tipping load for
pallet forks.
Example: If the centre of gravity of the
load is 970 mm in front of the front axle
(400 mm from the pallet forks at ground
level)
Tipping load is about 1230 kg with a
driver weighing 75 kg, and with the
articulated frame turned to max
articulation.
When lifting to horizontal position,
the tipping load is reduced to about
830 kg.
This means that a pallet with a total
weight of 1200 kg can be lifted just
off the ground.
https://tractormanualz.com
To Next Page
Loading...