AVANT e5 - Daily Inspections

Avant e5
73
.
Daily inspections
Do a walk-around check of the loader before each working shift. Check at least the following points. Do not use the
loader if you notice problems with any of the listed items.
Check before start
To check
1
Tyres: pressure and
condition

Check visually daily. Do not use if there is visible damage on tyres.

Check with pressure gauge if wrong pressure is suspected, see page 73
2
Level of hydraulic oil

Check level of hydraulic oil especially after using a new attachment that
drains hydraulic oil from the loader as the hydraulic system of the attachment
fills up. Check also after repairing a leak.
3
Need for lubrication

Make sure all joints are lubricated sufficiently, see page 76
4
Cleanliness of electric motor
compartment and radiators

Keep inner compartment of the loader clean to prevent electric motors and
systems from overheating

Check and clean external surfaces of electric motors, inverters, and charger.
Use damp cloth for cleaning

Dust, hay, and other dry materials inside the inner compartment will cause a
fire hazard
5
Clean and check the battery

Keep the top surface of the battery clean

Check the battery cables, connectors, and terminals visually. If a cable or its
insulation has become brittle, there is a risk of short-circuit. Replace cables
and insulators as necessary

In case of any trouble, or if you need more information, contact your Avant
dealer
6
Oil or other leakages

Check the underside of the loader. Also check ground/floor surface for signs
of leakage

Never operate if leakage is observed. Repair before use
7
General condition of the
loader

Check for damages on metal parts or rust

Ensure all safety decals are in place and legible
8
Condition of the safety
frame, seat belt, lamps, and
other safety equipment

Safety frame (ROPS) and protective roof (FOPS) must be fitted

Safety structures must not have visible damage or deformations. They must
be replaced after any incident

Make sure all lamps are functional and clean
9
Attachment and its locking

Check the locking of attachment and locking pins on attachment coupling
plate

Function of attachment, position of attachment hoses

See also the operator's manual of the attachment, see page 4
https://tractormanualz.com