AVANT e5 - Stopping the loader (Safe stopping procedure)

Avant e5
45
Battery disconnect switch
The loader is equipped with an electrically controlled
battery disconnect switch (main switch). The
automatic battery disconnect cuts the current
between battery and the rest of the electric system
whenever ignition key is switched to position OFF.
To switch on the electric systems of the loader, turn
the ignition key to position ON and wait for a few
seconds.
To start the loader:
1. Perform daily checks (see Maintenance &
Service on page 70)
2. Sit on the driver's seat, adjust seat, and fasten
seat belt
3. Move the hand throttle lever to idle position
4. Make sure that auxiliary hydraulics is switched
off (lever in neutral position), see page 32. Do
not press on the drive pedals.
5. Turn the ignition key to position ON
 Automatic battery disconnect switch will be
switched on when ignition key is in this
position
It is possible to turn the ignition key further,
beyond the position ON. However, this has
no effect on e5 loader model.
.
..
Make sure there are no remaining
warning messages on the
multi-function display after start. If
the motors do not start after you
have turned the ignition switch to
position ON, see troubleshoot on
page 87.
.
Stopping the loader (Safe stopping
procedure)
1. Lower the boom completely down
2. Stop any attachment (move auxiliary
hydraulics control lever to neutral position,
see page 32), set hand throttle to rear position.
Place attachment firmly on the ground
3. Engage parking brake
4. Stop the motors by turning the ignition key to
the OFF position (to the left)
5. Release auxiliary hydraulics pressure (see
page 62).
6. Prevent unauthorised use of the loader. Take
the ignition key with you.
Stop if you notice any of the following:
Stop the loader to a safe state as
soon as possible if you observe any
of the following symptoms. Find out
the cause before restarting.
 Battery charge level is below 10 %. Drive to
a charging location and avoid heavy load
 Electric motor rpm increases and/or
decreases suddenly by itself, even if you
don't move the throttle lever, or press the
pedals
 You notice sudden increase in vibration or
noise levels
Tips to increase battery life
 Store the battery in recommended
temperatures
 Operate the auxiliary hydraulics only at the
speed that is necessary for the attachment or
work. Too high flow will waste energy.
 Always switch off the auxiliary hydraulics
when not actively using the attachments.
https://tractormanualz.com