Use only spacers recommended by
the manufacturer. Too thick spacers
may damage the hydraulic motors.
Contact your Avant dealer for more
information.
Snow chains
Snow chains available at time of print of this manual
are listed in tyre table above. When using snow
chains, the fenders must be removed when using
larger tyre models.
There are two types of snow chains. See the table on
page 25 for a list of chains that are available for
the tyre size of your loader.
Check that snow chains fit without hitting any part of
the loader. Check also that the snow tyres will fit
when the loader is turned to maximum articulation.
.
Ballasted tyres
Some tyres can be filled with special type of heavy
foam that creates additional counterweight. The filled
tyres are also useful in area where frequent tyre
puncture with normal tyres would be expected.
When driving with a loader that has ballasted tyres,
the acceleration and stopping distances may be
increased.
Ballasted tyres do not have air pressure inside them
and do not require air pressure checks.
Ballasted tyres are heavy - Handle
ballasted tyres with care. Filling of
tyres should be left to professional
tyre service.
When the loader is equipped with ballasted tyres, the
following symbol must be applied to a visible location
on the loader frame near tyres. If you replace the
tyres and install normal tyres, make sure to also
remove this label.
https://tractormanualz.com
To Next Page
Loading...