Avant e5
47
Drive pedals
Driving forward: press gently on the right
drive pedal until the machine starts to move
slowly.
To drive backward: press gently on the left
drive pedal.
When you wish to stop gently release the
pedal by lifting of your foot, and the machine
will slow and stop.
If you need stop more quickly, press the drive pedal
of the opposite drive direction. Release both pedals
as soon as the loader has stopped, otherwise the
loader will immediately start to move to the direction
of the drive pedal that is pressed.
Driving/operating modes
1. Power mode
Use this mode when you need high speed or
high auxiliary hydraulics output.
Battery run time may be short as result.
2. ECO mode
Use this mode for maximum battery run time.
Management of electric systems and hydraulic
flow are optimised to avoid waste of energy.
Maximum speed and acceleration are limited.
3. Slow / inching mode
This mode provides modified response to drive
pedal. This helps you to operate the loader in
tight spaces, where great accuracy is needed,
or when learning to operate the loader.
.
When you want to have a high pulling
force:
Drive pedals adjust both speed and torque.
Pushing pedal further down will increase pulling
force and speed. Press pedal only as much as
needed
The position of the driving mode switch does not
affect pulling force
The position of the hand throttle lever does not
affect pulling force or drive speed
If battery is low, and a high speed is requested
with a drive pedal, the loader may not be able to
produce maximum pulling force. Push pedal
lighter in this case
OptiDrive™
The e5 loaders are equipped with efficient Avant
OptiDrive™ hydraulic drive system as standard.
The system is designed for optimal hydraulic oil flow,
which helps to conserve energy by minimising
losses. This is achieved with the use of integrated
high efficiency Avant valve blocks and new hose
fittings.
Drive release and anti slip
Drive release valve
The hydraulic drive circuit has a built-in drive release
system, which allows the wheels on the left and right
side of the machine to roll at different speeds to
leave less tyre marks on soft surfaces. The system
automatically limits the flow of hydraulic oil between
the hydraulic motors on each side, functioning in
similar way as a limited parallel differential lock,
increasing pushing force of the loader. The system is
always engaged.
Anti-slip valve (optional extra)
If the loader is equipped with optional anti-slip valve,
the valve positively diverts oil flow between the right
and left side hydraulic motors and improves traction
on slippery and uneven surfaces. Some oil will pass
between the left and right side of the loader, and also
through hydraulic motors themselves. This means
that even though all wheels do not slip and spin
equally, all provide maximum pushing force.
https://tractormanualz.com
To Next Page
Loading...