Avant e5
9
17. Follow all inspection, service and maintenance
instructions. If you notice any faults or
damages on the machine, these must be
repaired before starting operation.
18. Before any maintenance or repair operation
always stop and switch off the loader, lower
the boom down and release pressure from
hydraulic system. Read safety instructions for
maintenance on page 70.
19. Do not let any person operate this loader who
has not read safety instructions and is not
familiar with the safe and correct use of this
loader.
20. Never operate the loader or attachments while
under the influence of alcohol, drugs,
medication that may impair judgement or
cause drowsiness, or if not otherwise medically
fit to operate the equipment.
Safety devices are installed for your safety -
Never modify or bypass any safety function
Safety functions are installed for
your safety. Never modify or block
any of the safety systems of the
loader. If you notice that a system
is not in good condition, stop the
use of the loader and make sure
the is serviced.
Sudden movements can tip the machine over -
Risk of overturning
Movements, such as stopping,
turning, or lowering the boom
abruptly, can cause loss of
stability. Always drive slowly and
operate the controls of the loader
very carefully, especially when
handling heavy loads.
Articulated frame - Risk of overturning
Turning articulated frame can lead
to overturning of the loader on
inclined terrain or when driving at
high speed. Never turn frame
towards the slope while operating
on inclined ground.
Always drive slowly when carrying
load or when turning with the
machine.
Overload - Risk of overturning
The high lift capacity of the loader
makes it possible to exceed the
stability of the loader when
handling loads. Read the
instructions regarding maximum lift
capacity and load handling in this
Operator's Manual. Following the
instructions reduces the risk of
tipping the machine over its front
axle, but the operator must be
aware of the limits of the machine
and follow safe working practises
to avoid overturning of the
machine.
https://tractormanualz.com
To Next Page
Loading...