Configuring custom settings
227
• Enable (with password)—to enable the screensaver with a
password mode.
The following are the options available for the screensaver settings menu:
• Select—to select the currently highlighted setting.
• Back—to dismiss the screensaver mode menu.
Note: Some options do not appear, depending on configuration.
Disabling the Screensaver displays a message confirming your selection.
Enabling the screensaver in no password mode displays a message
confirming your selection.
Note: If the device configuration does not allow the use of a
password free screensaver, this menu option is unavailable to you.
Enabling the screensaver in password protected mode prompts you to
enter the password before logging in.
The screen lets you launch the user-defined password definition screen if
it is enabled in the configuration.
The text on screen displays Enter user password to activate screensaver
followed by a user input prompt.
The options, which are available for the Enable (with password) mode are
as follows:
• Ok—Screensaver enabled message appears if the password is valid.
Invalid password message appears if the password is invalid.
• 123/abc—to toggle input mode between numeric or alphabet.
• Set—context-sensitive soft key appears only if the feature allows the
setting of user-defined passwords. This key invokes a password
definition screen that allows you to configure a password.
• Back—to dismiss the Enable (with password) mode menu.
If the option to use a user-defined password is allowed, the interface
(screen) to configure the password, is accessed through the Set context-
sensitive soft key on that screen. If a user-defined password is not
To Next Page
Loading...
