Configuring custom settings
228
allowed, then the Set context-sensitive soft key is not visible, and you can
use only the primary user login password to enable the password–
protected screensaver.
After the screensaver is activated, if the IP Deskphone is idle for the
defined delay/time interval, the screensaver takes control of the
IP Deskphone.
The following option is available for the Enable (with password) mode:
• Unlock—if the screensaver is not password protected, this key press
(or any other) cancels the screensaver. If the screensaver is in a
password–protected mode, pressing the Unlock context-sensitive
soft key invokes a password input screen. The password must be
correctly entered to cancel the screensaver.
If you enable the screensaver with no password mode:
• Any user interaction, key presses, mouse movement, or incoming call
cancels the screensaver (without requiring a user password). This
includes pressing the Unlock context-sensitive soft key.
• The programmed keys of attached Expansion Module(s) are cleared
until the screensaver is deactivated. If you have logged on to the
IP Deskphone, you are not logged out, but the line key labels clear
and are inactive until the screensaver is deactivated.
If you reboot the IP Deskphone when there is an active screensaver:
• If you have enabled autologin, then the screensaver remains active
after the IP Deskphone reboots and completes the login.
• If you have not enabled autologin, then the screensaver setting
remains enabled, but not active, after you log back into the
IP Deskphone manually.
If you enable the screensaver with a password protected mode:
• User interaction, key presses, and mouse movements do not cancel
the screensaver.
• An incoming call displays showing caller ID and allows you to answer
the call. You cannot make outgoing calls, except an emergency call,
until you unlock the IP Deskphone. An Unlock context-sensitive soft
key appears on the screen. You can unlock the IP Deskphone after
answering the call.
To Next Page
Loading...
