Avaya 1600 Series - Using Auto-Creation

H323 Telephone Installation Page 46
Issue 23e (Friday, February 15, 2019)IP Office™ Platform 11.0
Comments on this document? infodev@avaya.com
2.5.4 Using Auto-Creation
When installing a large number of phones, unless the configuration has been pre-built, auto-creation can be used to
simplify the installation process. The auto-created users are automatically linked to the IP Auto-create user rights
settings. By default that set of user rights has outgoing calls barred.
· Auto Disablement of Auto Create
Leaving the auto-create extension and user settings enabled is strongly deprecated. For Release 9.1 and higher,
the system automatically disables the settings 24-hours after they are enabled.
· Not Supported with WebLM Licensing
The auto-create extension and user options are not useable on systems configured to acquire licenses from a
WebLM service.
To switch auto-create on/off:
1. On R11.0.4.0 and higher systems, the Default Extension Password must be set before auto-creation can
be enabled.
2. Using IP Office Manager, receive the configuration from the system. Select System.
3. Select the LAN1 or LAN2 tab depending on which of the system's LAN interfaces you want to use to support
H.323 extensions.
4. Select the VoIP sub-tab.
5. The Auto-create Extn and Auto-create User settings are used for H.323 phone installation. Set these as
required for the installation. If not enabled, it will be necessary to manually create the extension entries and
or manually create the user entries before installing the phones.
· On pre-11.0.4.0 systems, when Auto-create Extn is selected, you are prompt to set and confirm a
password. This value will be set as the Phone Password for any extensions created using auto-creation. The
phone password is used for registration.
6. If the settings have been changed, save the configuration back to the system.
44
45
44