Avaya 1600 Series - Creating a DHCP Scope for the IP Telephones

To Next Page

To Previous Page

H323 Telephone Installation Page 49

Issue 23e (Friday, February 15, 2019)IP Office™ Platform 11.0

Comments on this document? infodev@avaya.com

Installation: Static Address Installation

9600 Series Phones

1. When the option * to program is displayed, press the * key.

2. When Enter code is displayed, enter the administrative procedures passcode and press #. The default passcode

is CRAFT (27238).

3. Scroll the menu to ADDR and select this option to start the address procedure.

4. The list of required addresses is shown. If the phone had any existing values they are shown. Otherwise if the

phone is new or has been cleared , all the addresses are set to 0.0.0.0.

5. Set each address in turn by highlighting it and selecting Change. Enter the new address value and then select

Save. To enter a . in IP addresses press *. The values that need to be set are:

Phone =

This is the phone's IP address. To accept the current value, press # or enter a value and then press #. If

entering a new value, press the * key to enter a '.' character between digits.

Call Server =

This is the address of the H.323 gatekeeper. For IP Office systems this is the IP address of the IP Office LAN.

Router =

This is the address of the phone's default IP gateway. For IP Office this is typically the IP address of the IP

Office LAN. To accept the current value, press # or enter a value and then press #.

Mask =

This is the phone's IP Mask (also called the subnet mask). The mask is used with the IP address to indicate the

phone's subnet. This should match the IP mask set for the IP Office Unit.

HTTP File Server =

This is the address of the HTTP file server from which the phone should request software and settings files.

HTTPS File Server =

This is the address of the HTTPS file server from which the phone should request software and settings files.

The phone will attempt to use this address, if set, before using HTTP.

802.1Q =

To change the setting press *. Press # to accept the value.

VLAN ID =

For details of VLAN configuration, see VLAN and IP Phones .

VLAN Test =

When using VLAN, this is the time in seconds the phone will wait from a response from the DHCP server in the

VLAN before falling back to normal non-VLAN operation.

6. When all the values are set as required press Back.

7. Press Exit. The phone will restart using the new values.

8. The phone registration menu is displayed.

Other manuals for Avaya 1600 Series