Avaya 1600 Series - Page 66

H323 Telephone Installation Page 66
Issue 23e (Friday, February 15, 2019)IP Office™ Platform 11.0
Comments on this document? infodev@avaya.com
3. Static Administration Options
A number of settings can be altered through the phone after installation. These procedures should only be used if you are
using static address installation. Do not use these procedures if you are using DHCP except if you are attempting to
reassign a phone that has been previously statically installed.
· To set parameters for all H.323 IP phones on a system, you can edit the 46xxsettings.txt script file. However,
values assigned through static administration override any set through the 46xxsettings.txt file. They remain
active for the IP phone until a new boot file is downloaded.
· This section of documentation only includes a subset of the administration options. For a full list refer to the
appropriate LAN administrator's manual:
· Installing and Maintaining Avaya 9608/9608G/9611G/9621G/9641G/9641GS IP Deskphones H.323
http://support.avaya.com/css/P8/documents/101009345
· Administering Avaya 9608/9608G/9611G/9621G/9641G/9641GS IP Deskphones H.323
http://support.avaya.com/css/P8/documents/101009361
· VPN Setup Guide for 9600 Series IP Deskphones (16-602968)
http://support.avaya.com/css/P8/documents/101008050
· Avaya one-X Deskphone Edition for 9600 Series IP Telephones Application Programmer Interface
(API) Guide (16-600888)
Covers the configuration and use of WML and PUSH interfaces with 9600 Series telephones.
http://support.avaya.com/css/P8/documents/100165678
Using Static Administration Options
The method used to access static administration depends on the type of phone. Many of the static administration features
are accessed using key sequences that begin by pressing either MUTE or HOLD. In recent firmware releases, preference
has been given to using MUTE and some phones, for example the 1600 Series, only support MUTE.
1600 Series Phones
This section describes how to enter data for the administrative options.
1. With the phone idle, press MUTE. After pressing MUTE, if a valid button is not pressed within 6 seconds of the
previous button the collected digits are discarded and the phone returns to idle.
2. Dial the administrative process password .
3. Dial the digits for the required command followed by #.
· Attempts to enter invalid data are rejected and the phone emits an error beep.
· If a numeric digit is entered for a value or for a field of an IP address or subnet mask after only a zero has
been entered, the new digit will replace the zero.
· To go to the next step, press #.
9600 Series Phones
Administrative procedures for 9600 Series phones can only be accessed by restarting the phone.
1. While the phone is on-hook and idle, press the following sequence: MUTE <password> #.
2.Scroll the menu to the action required and select it.
3.When the selected procedure is finished, the phone will return to the procedures menu.
4.When all the required procedures have been completed, press Exit. The phone will restart using the new settings.
67
67