operate with the 5530-24TFD switch. Consult the documentation provided with the USB drive
to ensure compliance with these standards.
Important:
The USB port on the back panel of the Ethernet Routing Switch 5530-24TFD and Ethernet
Routing Switch 5600 Series models is not enabled.
Placement options and cables
The following sections describe the available placement option and requirements, as well as
cables for the Ethernet Routing Switch 5000 Series switch.
Environmental requirements
This module describes the environmental requirements for the Ethernet Routing switches.
The Ethernet Routing switches must be properly mounted in a dry, well-ventilated area with
adequate power available for optimum operation. See the environmental specifications in
Table
8: Job aid: Ethernet Routing Switch 5500 Series environmental requirements on page 58.
Placement options
You can mount 5000 Series switches on a flat surface such as a table or shelf, or in a rack.
Choose the mounting option that best suits your location. The following sections describe the
options.
Navigation
•
Switch installation on a table or shelf on page 25
• Switch installation on the wall on page 26
•
Switch installation in an equipment rack, front mount option on page 26
• Switch installation in an equipment rack, rear mount option on page 26
Choose the mounting solution that suits your requirements and site.
Switch installation on a table or shelf
You can mount 5000 Series switch on a flat surface such as a table or shelf. See
Mounting
on a table or shelf on page 62, to install a single unit on a table or shelf.
Placement options and cables
Avaya Ethernet Routing Switch 5000 Series Installation December 2010 25
To Next Page
Loading...
