Avaya 5000 Series - Console Port Pin Assignments; Ac Power Cord Specifications

Connector Pin
Number
Signal for
10/100Base-T MDI
configuration
Signal for
10/100Base-T MDI-X
configuration
5 TP2- TP3-
6 TP1- TP0-
7 TP3+ TP2+
8 TP3- TP2-
Console port pin assignments
The following section outlines the console port pin assignments in the Avaya Ethernet Routing
Switch 5500 Series.
Table 17: Console port pin assignments
Connector Pin number Signal
1 Carrier detect (not used)
2 Transmit Data (TXD)
3 Receive Data (RXD)
4 Data terminal ready (not used)
5 Signal ground (GND)
6 Not used
7 Request to send (not used)
8 Not used
9 Ring indicator (not used)
AC power cord specifications
The following section outlines the AC power cord specifications for various countries. Ensure
that you use the correct cord for your location.
Table 18: International power cord specifications
Country / Plug Specification Specifications Typical Plug
Continental Europe:
• CEE7 standard VII male plug
• Harmonized cord (HAR marking on
the outside of the cord jacket to
• 220 or 230 VAC
• 50 Hz
• Single Phase
Installation reference
94 Avaya Ethernet Routing Switch 5000 Series Installation December 2010