Figure 18: SFP transceiver
IP address information configuration
The following sections contain information necessary to configure IP address parameters on
the switch.
Connecting a console
This procedure describes the steps to connect a console.
Prerequisites
• Terminal with AC power cord and keyboard.
• Serial cable with a DB-9 female connector on both ends. The maximum length for the
console port cable is 25 feet (8.3 meters).
1. Connect one end of serial cable to the DB-9 connector on the terminal.
2. Connect the other end of the serial cable to the DB-9 connector on the switch.
3. Turn the terminal on.
Accessing the console menu
This procedure describes the steps used to access the console menu.
IP address information configuration
Avaya Ethernet Routing Switch 5000 Series Installation December 2010 81
To Next Page
Loading...
