Figure 4: Cascade down configuration
Important:
Since many network management software packages assume a cascade down (stack
down) configuration, Avaya recommends the usage of this configuration.
For stack installation procedures, see Stack configuration on page 85.
Cascade up
In a cascade up (stack up) configuration, the base unit is physically located as the top unit in
the stack. The cable connected to the Cascade Down connector of the base unit terminates
in the Cascade Up connector physically located at the bottom of the stack. This next unit is
designated Unit 2. The stack is wired upward through the units and the system continues to
number in this manner throughout the stack. In this configuration, the base unit discovers the
Placement options and cables
Avaya Ethernet Routing Switch 5000 Series Installation December 2010 31
To Next Page
Loading...
