Label Color / Status Description
Amber / fast blinking System will reset in less than 1 second. To stop the
reset, release UI push button.
Note:
The UI button is labeled Mode Select on Avaya
branded equipment.
Off The switch is not connected to an AC power source or
the power supply unit is not supplying power.
Status Green / steady
• During Initialization: The power-on self-test is
complete and the switch is operating normally.
• After Initialization: The front panel configuration
mode is inactive. Unit booted successfully.
Green / blinking
• During Initialization:: A non-fatal error occurred
during the self-test.
• After Initialization: The user pushed the UI button
and activated the front panel configuration mode
and the system is awaiting input.
Amber / steady
• During Initialization: N/A
• After Initialization: The front panel has accepted the
user command. The system accepts the UI input and
is awaiting execution.
Amber / blinking
• During Initialization: N/A
• After Initialization: The system has rejected the UI
input.
Off The switch failed the self-test.
RPSU Green / steady The switch is connected to a redundant power supply
unit (RPSU) and is receiving power if necessary.
Off The switch is not connected to a RPSU, the RPSU is
not supplying power, or the DC/DC module is not
supplying power.
Up Green / steady The Cascade Up port has a physical connection to
another unit.
Amber / steady The Cascade Up port has detected an error.
Off The switch is in standalone mode or there is no link to
the Cascade Up port.
Down Green / steady The Cascade Down port has a physical connection to
another unit.
Amber / steady The Cascade Down port has detected an error.
Procedures for installation of the switch
76 Avaya Ethernet Routing Switch 5000 Series Installation December 2010
To Next Page
Loading...
