Label Color / Status Description
LNK/ACT Amber / steady PoE DTE short or the power allocated to this port has
been exceeded.
Amber / blinking Power budget exceeded.
Green / steady Link established but no data activity.
Green / blinking There is activity on this port. The blinking rate indicates
the level of activity.
Off No link.
Table 13: Shared SFP transceiver Port LED state indicators
Label Color / Status Description
In Use Green / steady The port has a link established.
Off The port does not have a link established.
LNK/ACT Green / steady This link is operating normally.
Green / blinking There is activity on the port.
Green / slow blinking The port has been disabled by the software.
Off Indicates that the link has been lost.
Table 14: XFP transceiver port LED state indicators
LED Color / Status Description
Tx Green / steady
Rx Green / steady
Link established.
Tx Green / blinking Transmit activity detected.
Rx Green / blinking Receive activity detected.
Tx Amber / steady Transmit activity enabled.
Rx Amber / steady Fiber connected with signal present.
Tx Amber / blinking XFP has been installed. Laser Transmitter OFF or XFP in Reset.
Rx Amber / blinking XFP has been installed. No Signal Detected or XFP in Reset.
Both Off No XFP installed.
The Amber LEDs are usually only used during the boot process. Under normal operation,
Green is the only color the XFP LED should emit.
Procedures for installation of the switch
78 Avaya Ethernet Routing Switch 5000 Series Installation December 2010
To Next Page
Loading...
