5. Select Command Line Interface. . . from the main menu.
6. Enter the Global Configuration command mode using the enable and configure
terminal commands.
7. In the Global Configuration command mode, use the ip address command to
set the switch or stack IP address.
8. Initial IP configuration is now complete. To continue with configuration operations,
use the appropriate CLI commands. To disconnect from the switch use the logout
command to return to the Console Menu and select Logout from the main menu.
Job aid
Any terminal or PC with an appropriate terminal emulator can be used as the management
station. The following table lists the parameters that must be used with any terminal emulation
software used to connect to the switch.
Table 15: Terminal emulation settings
Property Value
Baud Rate 9600 bps
Data Bits 8
Stop Bits 1
Parity None
Flow Control None
Assigning IP parameters using the UI/Mode Select button
This procedure describes the steps to assign IP parameters using the UI button.
Note:
The UI button is labeled Mode Select on Avaya branded equipment.
1. Press and hold the UI button for 3 seconds.
The unit enters configuration mode. The Status LED changes to a blinking green
status.
2. Press the UI button 5 times.
IP address information configuration
Avaya Ethernet Routing Switch 5000 Series Installation December 2010 83
To Next Page
Loading...
