Why are HTTP/HTTPS script and settings files ignored on Avaya 9641GS Telephone?
If the HTTP/HTTPS script file and settings file are ignored by your Avaya Telephone, it may be because the system value AUTH is set to 1 (HTTPS required) but no valid address is specified in TLSSRVR. Change AUTH to 0 (zero), or enter a valid address for TLSSRVR.
Why do MS Exchange contacts take too long to load on Avaya 9641GS?
If MS Exchange contacts take too long to load on your Avaya Telephone, verify that the MS Exchange server being used is specified in the settings file, because the correct Exchange server is not specified in the parameter EXCHANGE_SERVER_LIST in the 46xxsettings file.
Why does Avaya Telephone have reorder tone after dial tone?
When a line is selected on your Avaya Telephone and you hear a short dial tone burst followed by a reorder/fast busy tone, map the extension on the off-pbx-telephone station-mapping form. Also, check SIG group configuration, because possible error in SIG group configuration on Communication Manager, which indicates the default region for the SIP trunk to Communication Manager.
Why are DTMF tones not received on Avaya 9641GS Telephone?
If your Avaya Telephone works properly except for receiving incoming DTMF tones, there is no solution. The TN2302AP board does not pass in-band DTMF tones, and it is operating as designed.
General| Type | IP Phone |
|---|---|
| Resolution | 480 x 272 pixels |
| Connectivity | Ethernet |
| USB Ports | 1 |
| Bluetooth | Yes |
| Power over Ethernet | Yes |
| Ethernet Ports | 2 |
| Headset Jack | Yes |
| Speakerphone | Yes |
| SIP Support | Yes |
| H.323 Support | Yes |
| Lines | 6 |
| Network Protocol | SIP, H.323 |
| Display | Color |
| Audio | Wideband |
| PoE | 802.3af (Class 3) |
| Buttons | 24 programmable keys |
| Supported Codecs | G.711, G.722, G.729 |
To Next Page
