Avaya J100 - Page 263

Parameter name Default
value
Description
SLMSTAT 0 Specifies if the SLA Monitor agent
is enabled or not.
Value Operation:
• 0: Disabled
• 1: Enabled
SNMPADD Null Specifies a list of source IP
addresses from which SNMP query
messages will be accepted and
processed.
Addresses can be in dotted-decimal
format (IPv4), colon-hex format
(IPv6, if supported), or DNS name
format, separated by commas
without any intervening spaces.
The list can contain up to 255
characters. The default value is
null.
SNMPSTRING Null Specifies a security string that must
be included in SNMP query
messages for the query to be
processed.
Valid values contain 0 through 32
ASCII alphanumeric characters.
The default value is null. Null
disables SNMP.
SNTP_SYNC_INTERVAL 1440
minutes
Specifies the time interval, in
minutes, during which the phone
will attempt to synchronize its time
with configured NTP servers. Valid
values are from 60 to 2880
minutes.
SNTPSRVR Null Specifies a list of addresses of
SNTP servers.
Addresses can be in dotted-decimal
or DNS name format, separated by
commas without any intervening
spaces.
The list can contain up to 255
characters.
Table continues…
List of configuration parameters
December 2018 Installing and Administering Avaya J100 Series IP Phones 263
Comments on this document? infodev@avaya.com