TSC-ADM (Administered Temporary Signaling
Connections)
Issue 1 May 2002
8-1201555-233-142
1148 ABORT The ADM TSC is enabled, but inactive (near end).
1. Disable and enable the ADM TSC.
2. Reissue the test tsc-administered command.
3. If the ADM TSC is still inactive, check the other nodes in the network.
1149 ABORT The ADM TSC is disabled.
1. Enable the TSC, and see if the status indicates “active.”
2. Reissue the test tsc-administered command.
3. If the TSC still disabled, remove the ADM TSC from the system.
1181 ABORT Ran out of ADM TSC resources.
1. Reissue the test tsc-administered command at 1-minute intervals up to 3
times.
1182 ABORT The BX.25 link is down at the gateway.
1. Disable the ADM TSC.
2. Check the status of the gateway link via the status link link-num
command.
3. Once the gateway link indicates an “in-service” state, enable the
Administered TSC.
4. Reissue the test tsc-administered command.
2000 ABORT The Administered TSC is not responding to a TSC heartbeat inquiry.
1. Retry the test tsc-administered command at 1-minute intervals up to 3
times.
2. If the problem continues to fail, obtain the status of the D channel or
D-channel pair associated with the ADM TSC via the status sig-group
<group> command. If the D channel is INS (i.e., in-service) and the status
of the ADM TSC appears to be active, then disable and enable the ADM
TSC through administration.
NOTE:
To disable the ADM TSC, display the (administration) Signaling Group
Form via the change sig-group <group> command where <group>
refers to the number of the signaling group under which the suspect TSC
is administered. Change the “Enable” field to “n.” To enable the ADM
TSC, change the “Enable” field to “y.”
3. Reissue the test tsc-administered command.
4. If the test fails, check the ADM TSC node on the other side of the network
to verify that the ADM TSC is indeed active.
Table 8-511. Test #604 TSC Heartbeat Inquiry Test — Continued
Error
Code
Tes t
Result Description / Recommendation
Continued on next page
To Next Page
Loading...
