• Connect one end of the USB cable to the USB socket on the Avaya Scopia
®
XT Camera
Switch and the other end to the upper USB connector on the XT Codec Unit. This cable
provides power to the device, so no extra power cable is required.
Figure 27: Connecting the Avaya Scopia
®
XT Camera Switch to the XT Codec Unit
3. Insert the three connectors of the camera cable (3 connectors on one side, 2 connectors on
the other side) to the sockets on the back of the camera, as shown in
Figure 23: Connecting
cables to the back of the camera on page 51:
• The DVI connector to the DVI socket
• The 8-pin connector to the IN RS232C socket
• The power connector to the DC IN 12V socket
Setting Up the XT Series Hardware
January 2017 Avaya Scopia
®
XT Series Deployment Guide 56
Comments on this document? infodev@avaya.com
To Next Page
Loading...
