T7316 Telephone User Guide Page 20
- Issue 02a (03 October 2011)IP Office
2.6 Pre-Dialing (Enbloc)
By default, when you start dialing a number, your phone immediately connects to the telephone system. It then starts
passing the digits you dial to the phone system as and when you dial them. However, in this traditional dialing mode, you
cannot correct the digits you have already dialed except by ending the call and starting again. Also if you pause dialing for
too long the phone system may think that you have finished dialing and will attempt to connect the call using only the
digits you have completed dialing so far.
Pre-dialing or enbloc dialing allows you to compose and edit the number to dial on your phone's display before you send it
to the phone system to be dialed.
Through the phone's menus you can select whether you want to use traditional or enbloc pre-dialing when you make
calls.
Dialing a Number Using En-Bloc Mode
1.
Without going off-hook to hear dial tone, start dialing.
2.
You can use the key (or the <<< soft key) to delete the previous digit dialed if you need to correct the
number.
3.
When you have completed the number as required, you can select how you want to make the call.
· Lift the handset to start a call using the handset.
· Press one of your idle call appearance buttons to start a call handsfree using that appearance.
· Press the Speaker button to start the call on your phone's handsfree speaker.
· Press the Headset button to start the call on a headset connected to your phone.
Enabling/Disabling En-Bloc Dialing
You can enable or disable your enbloc pre-dialing using Feature 82. When on, you can compose a number to dial
without the digits being dialed until the number is complete.
· This function can be assigned to a programmable button . This allows it to be accessed in a single key press. If
the button includes an indicator, it will indicate the status of the function (on or off).
1.
Press Feature *82.
2.
The phone displays Enbloc dial and the current setting.
3.
Press the on or off soft key to change the setting.
20
69
To Next Page
Loading...
Need help?
General
