T7316 Telephone User Guide Page 68
- Issue 02a (03 October 2011)IP Office
12.4 Auto Dial Button
A button set to this function dials a stored number. That number can be any number composed of the digits 0 to 9 plus *
and #. It can be an internal or an external number. It can be a partial number that you complete dialing after pressing the
button. It can also be a system short code for a telephone system feature. This button function is also known as Auto
Dial and External Auto Dial.
· ! Warning
This process will overwrite the existing function of a programmable button without any warning.
1.
Press Feature *1.
· If a security code is requested, enter your phone login code and press #.
2.
Press the button to program.
· You cannot override the programming of any button configured to a call appearance function by your system
administrator.
· On buttons that you can program, any existing function is overwritten without warning. If in doubt, use
Feature *0 to inspect the button first.
3.
Enter the number you want stored by the button. This can be a partial number which you will complete after
pressing the button.
· The button deletes the last digit entered. The <<< soft key can also be used. The Clear soft key deletes
the whole number entered.
4.
When the number is complete, press Hold (or press the OK soft key).
12.5 Internal Auto Dial (User Button)
A button set to this function calls another user. The button can also be used to see the current state of the other user. The
button's icon will flash when the other user has a call alerting them. When that is the case, pressing the button answers
their call. When the icon is steady the user is busy.
· ! Warning
This process will overwrite the existing function of a programmable button without any warning.
1.
Press Feature *2.
· If a security code is requested, enter your phone login code and press #.
2.
Press the button to program.
· You cannot override the programming of any button configured to a call appearance function by your system
administrator.
· On buttons that you can program, any existing function is overwritten without warning. If in doubt, use
Feature *0 to inspect the button first.
3.
Enter the extension number of the user for who you want a button.
· The button deletes the last digit entered. The <<< soft key can also be used. The Clear soft key deletes
the whole number entered.
4.
As soon as a valid number is entered, the value is saved and the button set.
12
To Next Page
Loading...
Need help?
General
