3 — Operation
Service Instructions RP-A301CE/RP-A351CE/RP-A355CE 3 - 35
3. Loosen the product holder by rotating
the product holder clamping handle in
a counterclockwise direction.
4. Push the product holder towards the
operator until it clicks. The click will
inform the operator that the product
holder is clamped.
5. Lift the product holder from the
carriage.
Note:
The slice thickness control must be set at
zero.
Blade cover
1. Loosen the blade cover fastener
handle by rotating it in a
counterclockwise direction.
2. Push on the handle in the direction
indicated by the arrow to lift the blade
cover from the blade.
To Next Page
Loading...