Avery Dennison Label Printer - Opening an Existing Project

Avery
®
Personal Label Printer
79
Opening an Existing Project
There are three ways to open a previously saved project. All three methods take you to the
Open dialog box.
• From the Welcome Screen, select Open an Existing Project.
• From the Design screen, select File > Open or press Ctrl+O on the keyboard.
• From the Design screen, click Open on the Standard toolbar.
The Open Dialog Box
Look in - Locate and select the previously saved DesignPro project on your computer. If
opening a LabelPro project, change the Files of type selection first.
Preview - Displays a preview of the selected file. A preview is displayed only if the file was
previously saved with a corresponding preview graphic in the Save As dialog box.
Files of type - If you are opening a project created by one of the following programs, change
the file type accordingly. For instance, select LabelPro 2.0 - 3.02 (*.lpd) if opening an
Avery
®
LabelPro
®
project. You can open and reuse files from the listed Avery software.
However, it is not possible to save files in these formats.
The following file formats are supported by DesignPro:
• DesignPro (*.zdp)
• LabelPro 2.0 - 3.02 (*.lpd)
• WinLabel 3.0 (*.zwl)