Installation and Setup 13
Enabling EUCON in Pro Tools
When you first connect your Dock, you must enable EUCON in Pro Tools, EUCON subsequently remains enabled in Pro Tools un-
less you disable it. To enable EUCON in other DAWs, see the documentation provided by the manufacturer.
To enable EuControl in Pro Tools:
1 Launch Pro Tools. If the Dashboard dialog appears, close it.
2 Choose Setup > Peripherals, and click the Ethernet Controllers tab.
3 Select Enable EUCON.
4 Click OK. You do not need to configure any other Ethernet Controllers settings. These settings do not apply to EUCON.
Pro Tools scans your system until it identifies attached EUCON-compatible hardware. When Pro Tools finishes scanning your
system, your controllers are ready to use with Pro Tools.
5 Proceed to Confirming EUCON.
Enable EUCON check box
While Pro Tools is connected to a EUCON surface do not uncheck to disable and re-check to enable without a complete restart
of all components (surfaces and Pro Tools computer) after disabling and before re-enabling.
Before ever de-selecting Enable EUCON be sure to go to EuControl Settings > Surfaces and remove all attached surfaces.
To learn how to configure EuControl for other EUCON-compatible applications see the EUCON Application Setup Guide.pdf.
To Next Page
Loading...
