Pro Tools | MTRX Studio Installation Guidevi
EMC (Electromagnetic Compliance)
Avid declares that this product complies with the following standards:
• FCC Part 15 Class A
• EN 55032:2012, Class A
• EN 61000-3-2:2014, AC Mains Harmonic Current
• EN 61000-3-3:2013, AC Mains Voltage Variations and Flicker
• EN 55103-1:2009, Emissions Environment E4
• EN 55103-2:2009, Immunity Environment E1–E4
FCC Compliance for United States
Safety Compliance
This equipment has been tested to comply with EN 60950-1:2006 + A11:2009 + A1:2010 + A12:2011
+A2:2013
Power Safety Input Rating
Pro Tools | MTRX Studio: 100-240 VAC, 50/60 Hz, 45 VA Max.
Note:
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial environ-
ment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful in-
terference in which case the user will be required to correct the interference at his own expense.
Cables:
Connections to Avid hardware must be made with shielded cables with metallic
RFI/EMI connector hoods in order to maintain compliance with FCC Rules and Regulations.
Any modifications to the unit, unless expressly approved by Avid, could void the user's authority
to operate the equipment.
To Next Page
Loading...
Need help?
General
