Resetting to Factory Default Settings
If the device no longer functions as expected, you can choose to reset the device to its factory default
settings.
Use the firmware revert button to reset the device. The firmware revert button is shown in the following
diagram:
1. Ensure the camera is powered on.
2. Remove the cover.
3. Using a straightened paperclip or similar tool, gently press and hold the firmware revert button.
4. Release the button after 3 seconds.
5. The LEDs beside the I/O connector block will turn off.
Wait while the camera reverts to the factory default settings.
Resetting to Factory Default Settings 41
To Next Page
Loading...
