Avigilon H5SL Series User Manual

Connecting to External Audio and I/O Devices
Important: This product is intended to be supplied by Power over Ethernet (PoE). Do NOT connect
auxiliary power to the audio or I/O wires or the camera will be damaged.
WARNING — This product is intended to be supplied by Power over Ethernet (PoE) that is a
“Limited Power Source” or “LPS”, rated 48VDC, 9W min.
External audio and I/O devices are connected to the camera through the audio and I/O wires. The pinout for
the wires is shown in the following diagram:
1. Grey — Audio Input (line level)
An external power amplifier should be used when connecting speakers and microphones, as shown
in the diagram.
2. Red — Audio Ground
3. Pink — Audio Output (line level)
4. Green — Ground
5. Yellow — Digital Input
6. Brown — Digital Output
l * — Relay
l ** — Switch
l M — Microphone
l S — Speaker
Connecting to External Audio and I/O Devices 16

Avigilon H5SL Series Specifications

General

Ingress Protection	IP66
Impact Rating	IK10
Day/Night	Yes, with IR cut filter
Wide Dynamic Range (WDR)	Yes, up to 120 dB
Video Compression	H.264, H.265, MJPEG
Ethernet	10/100BASE-T
Resolution	5 MP
IR Illumination	Yes
Operating Temperature	-40°C to 50°C (-40°F to 122°F)
Power	PoE, 12V DC
Sensor Type	CMOS
Lens Type	Fixed or varifocal
Iris	P-Iris
IR Distance	Up to 30m (98ft)
Frame Rate	Up to 30 fps
Analytics	Yes
Aperture	F1.6
Minimum Illumination	0 lux (IR on)