Notes to print the patch codes:
Use blank white paper.
Set the scaling to 100%. The sheet is not recognized correctly when printed in
a size smaller than the original.
Do not use toner saving mode. The sheet is not recognized correctly when the
print is too light.
Do not use thin paper in order to avoid bleed-through from the back.
When you copy a patch code sheet that you printed out, make sure to copy by
the same size and brightness as the original copy.
Use the same sheet repeatedly may decrease the recognition accuracy due to
accumulated dirt on the sheets. If the sheet is not recognized correctly or gets
smudged, replace it with a new sheet.
To Next Page
Loading...
