What to do if AVM FRITZ!WLAN USB Stick Adapter cannot register at the WLAN remote site because of 5-GHz?
If you cannot register at the WLAN remote site, and the WLAN remote station transmits in the 5-GHz frequency band (802.11n/a mode), switch the WLAN remote station to 2.4-GHz transmission (802.11n/g/b mode, channel 1 - 13).
What to do if AVM FRITZ!WLAN USB Stick no WLAN remote sites are found?
If no WLAN remote sites are found, the WLAN remote site has not been turned on or is located too far away from the FRITZ!WLAN USB Stick. Make sure that the power supply of the WLAN remote site is secure and that the device is switched on. Check whether the WLAN remote site is within transmission range of the FRITZ!WLAN USB Stick.
How to fix AVM FRITZ!WLAN USB Stick Adapter connection to an access point using Microsoft WLAN Service (WZC)?
If the connection to an access point cannot be established using the Microsoft WLAN Service (WZC) in Windows XP with Service, the required Microsoft patch for WPA2 (IEEE 802.11i) may not be not installed. Install the current patch from Microsoft.
What causes an undefined malfunction with AVM FRITZ!WLAN USB Stick?
If an undefined malfunction occurs, radio traffic is subjected to interference by strong irradiation. Switch the WLAN channel setting on the access point.
Why AVM Modem computer recognizes network but cannot access internet?
If your computer with AVM Modem recognizes the network and router but has limited connectivity, the WLAN key might be incorrect, or the IP address was not assigned automatically by Windows. Ensure the WLAN key is entered correctly. Also, verify that the automatic assignment of IP addresses is enabled in your operating system. Note that the IP address assignment can take up to three minutes.
What to do if my AVM Modem finds no WLAN remote sites?
If no WLAN remote sites are found with your AVM Modem, it might be because the WLAN remote site is either not turned on or is too far from the FRITZ!WLAN USB Stick. Ensure the WLAN remote site is powered on. Also, check if the WLAN remote site is within the transmission range of the FRITZ!WLAN USB Stick.
General| Wi-Fi | Yes |
|---|---|
| Wi-Fi band | Single-band (2.4 GHz) |
| Data link protocols | IEEE 802.11b, IEEE 802.11g, IEEE 802.11g++ |
| Security algorithms | WPA, WPA2 |
| Maximum data transfer rate | 125 Mbit/s |
| Dimensions (WxDxH) | 132 x 138 x 35 mm |
| Compliance industry standards | IEEE 802.11b, IEEE 802.11g, IEEE 802.11i |
| Supported data transfer rates | 11 Mbit/s, 54 Mbit/s, 125 Mbit/s |
| Compatible operating systems | Windows Vista x64 Edition, Windows Vista, XP Professional x64 Edition, Windows XP/2000 |
| Connectivity technology | Wireless |
| Component for | PC/Laptop |
Weight and Dimensions| Weight | 125 g |
|---|
Lists all items included in the FRITZ!WLAN USB Stick package.
Specifies the system requirements needed to operate the FRITZ!WLAN USB Stick.
Explains the function and meaning of the LEDs on the FRITZ!WLAN USB Stick.
Details the technical specifications of the FRITZ!WLAN USB Stick hardware.
Describes the process of establishing a secure WLAN connection using Stick & Surf technology.
Step-by-step instructions for installing the FRITZ!WLAN USB Stick on Windows 8.
Instructions for installing the FRITZ!WLAN USB Stick on Windows 7 and Vista (32-bit).
Instructions for installing the FRITZ!WLAN USB Stick on Windows 7 and Vista (64-bit).
Step-by-step guide for installing the FRITZ!WLAN USB Stick on Windows XP (32-bit).
Instructions for installing the FRITZ!WLAN USB Stick on Windows XP (64-bit).
Provides information on establishing WLAN connections after installation.
How to open and use the FRITZ!WLAN control software interface.
Explains the context menus and how to interpret connection status icons.
Guides on how to establish different types of WLAN connections.
Steps to establish a connection with a WLAN access point using the software.
Instructions for creating and joining ad-hoc WLAN networks directly between devices.
Detailed steps for a device to join an existing ad-hoc WLAN network.
How to connect to the Internet using a WLAN access point.
How the computer itself establishes Internet connections.
Explains the default WLAN software and how to switch to Microsoft WLAN Service.
Steps to establish a WLAN connection using Microsoft WLAN Service in Windows 8.
Instructions for establishing a WLAN connection via Microsoft WLAN Service in Windows 7.
Steps for establishing a WLAN connection using Microsoft WLAN Service in Windows Vista.
Guide to establishing a WLAN connection via Microsoft WLAN Service in Windows XP.
Discusses different WLAN standards like 802.11a, b, g, n, and i.
Details the throughput rates for various WLAN standards.
Explains factors affecting WLAN range and signal strength.
Covers security standards like WPA, WPA2, and their encryption mechanisms.
Details security encryption mechanisms such as WEP, WPA, and WPA2.
Explains the 2.4 GHz frequency band, channels, and potential interference.
Describes the WPS procedure for establishing secure WLAN connections.
Step-by-step guide for establishing a WLAN connection using the WPS method.
Instructions for removing the FRITZ!WLAN USB Stick software and entries.
Details common causes and remedies for errors encountered during software installation.
Provides guidance on troubleshooting issues where a WLAN connection cannot be established.
Addresses problems related to data exchange errors between devices in a network.
Explains how to check and adjust IP settings for network connectivity troubleshooting.
Information on using Microsoft Service Packs to resolve operational problems.
Lists available documentation like FRITZ!WLAN Help, Readme, and Manual.
Details on accessing FAQs and other information on the AVM website.
How to download and install software updates for the FRITZ!WLAN USB Stick.
Guidance on contacting the AVM support team for assistance.
To Next Page
