Axia xNode - Page 61

C: AES67 • 53
© 2016 Axia Audio - Rev 2.0
The xNode makes a SIP call to the specied source. The call is receive only (issued with recvonly SIP/SDP media
attribute specied).
The xNode will provide status of the unicast connection on the front panel. Small triangle icons below the meters
show the current status:
• If no triangle is shown, the Source and Destination port is not congured for Unicast.
• If the triangle is blinking, the port is congured for Unicast, but there is no active connection.
• When the triangle is displayed solid on, there is a Unicast Link established to that port.
Channel/Address eld accepts optional UDP port number in the URI, separated with a “:” from the address part.
This is needed when the port number used by sender is different than SIP default 5060.