AXIS M7014
System Options
RTSP
The RTSP server running in the Axis product allows a connecting client to start an H.264 stream. The RTSP port number can be
changed under System Options > Network > TCP/IP > Advanced. The default port is 554.
Note
H.264 video streams will not be available if the R TSP server is disabled.
SOCKS
SOCKS is a networking proxy protocol. The A xis product can be configured to use a SOCKS server to reach networks on the other
side of a firewall or proxy server. This functionality is useful if the A xis product is located on a local network behind a firewall, and
notifications, uploads, alarms, etc need to be send to a destination outside the local network (for example the Internet).
SOCKS is configured under System Options > Network > SOCKS . For more information, see the online help
.
QoS (Quality of Service)
QoS (Quality of Service) guarantees a certain level of a specified resource to selected traf fic on a network. A Qo S-aware network
prioritizes network traffic and provides a greater ne twork re liability by controlling the amount of bandwidth an application may use.
TheQoSsettingsareconfigured under System Options > Network > QoS. Using DSCP (Differentiated Services Codepoint) values, the
Axis product can mark the following types of traffic: live video, event/alarm traffic and management traffic.
SMTP (email)
To send email messages from the Axis product via SMTP (S imple Mail Transfer Protocol), an SMTP mail server must be set up. This
is done under System Options > Network > SMTP (email).
Enter the host names or IP ad dresses and port numbers for the primary and secondary mail servers in the fields provided. A From
email address is also required. If the mail server requires authentication, check Use authentic
ation to log in to this server and enter
the necessary information.
SNMP
The Simple Network Management P rotocol (SNMP) allows remote m anag ement of network devices. An SNM P community is the
group of devices and management station running SNMP. Commu
nity names are used to identify groups.
The Axis product can be configu red to support SNMP on the
System Options > Network > SNMP page.
Depending on the level of security required, sel
ect the version on SNMP to use.
SNMP v1/v2 provides the lowest level of sec
urity. The community name can be specified as a password for read or read/write
access to all supported SNMP devices. The default p assword for the Read community is public and the default password for the
Write community is write.
Note
If HTTPS is enabled, SNMP v1 and SNMP v2c should be disabled.
Traps for SNMP v1/v2 are u se d by the A xis product to send messages to a management system on important events and status
changes. Check Ena
ble t raps and enter the IP address where the trap message should be sent and the Trap community that
should receive the message.
The following traps are available:
•Coldstart
•Warmstart
•Linkup
33
To Next Page
Loading...
