Axis M7014 - Reset to factory default settings

AXIS M7014
System Options
Reset t o factory default settings
This will reset all parameters, including the IP address, to the factory default settings :
1. Disconnect power from the product.
2. Press and hold the Control button and reconnect power (see Hardware overview, on page 4 ).
3. Keep the Control button pressed for about 15 seconds until the Status indicator flas hes amber.
4. Release the Control button. The process is complete after about 1 minute (when the Status indicator turns green). The
product has been reset to the factory default settings. The default IP address is 192.168.0.90
5. Re-assign the IP address.
It is also possible to reset parameters to factory default via the web interface. G o to Setup > System Options > Maintenance.
38