AXIS Q6032-E PTZ Dome Network Camera
PTZ (Pan Tilt Zoom)
the most movement w ill be followed. Autotracking continues until the m oving object stops or disap pears from the monitored area.
Movement in areas b locke d by privacy masks and in exclude areas does not trigger autotracking.
It is strongly recommende d to enable the PTZ Control Queue if autotracking and guard tour are enabled simultaneously. In the PTZ
Control Queue, guard tour has lower priority than autotracking, so autotracking will not be abandoned to start a guard tour.
Configuration
Start/Stop Autotracking - Click Start to enable autotracking. To disable autotracking, click Stop.
Settings - The Movement trigger sensitivity level can be set to Low, Medium or High. Medium is u sually a good choice, depending on
the size of the moving objects and the image contrast, a low or high sensitivity might be more suitable.
Exclude A reas
Exclude areas are areas wh ere movement is to be ignored.
Note
Movement in an area blocked by a privacy mask is always ignored.
1. Click Add area to create an exclude area
2. Resize and move the area (the blue rectangle) to the desired position.
3. Enter a descriptive n ame and click Save.
To remove an area, click the name of the area and click Remove. To enable or disable an area, click the name of the area and
click Enable/Dis able.
Max Limits
The pan and tilt limits r estrict the area wher e a utotracking is allowed. The area beyo
nd the set limits will be ignored. This may prove
useful, for example, to avoid tracking birds in the sky. Between the pan start an d e nd limits , autotracking is allowed going clockwise.
The illustrations show the difference between setting a range from 135° to 45° (1) and a range from 45° to 135° (2).
1. Select Enable tilt limit and Enable pan limit respectively to enable the tilt a nd pan limits.
2. Enter the Tilt angle a nd Pan limit values, o r click the links and mo ve the blue horizontal and vertical bars in the preview
window until satisfied.
3. Click Save.
24